Porter Cable N039112 Air Compressor Manual

The Porter Cable N039112 is a compact air compressor designed for a variety of tasks including inflating tires, powering pneumatic tools, and more. It features a 6-gallon tank, a maximum pressure of 150 PSI, and a low amp motor that allows for easy start-up in cold weather. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI maximum pressure, low amp motor, quick coupler, and pressure gauge.

Feature	Description
6-Gallon Tank	Provides ample air storage for various tasks
150 PSI Maximum Pressure	Allows for efficient operation of pneumatic tools
Low Amp Motor	Facilitates easy start-up in cold weather
Quick Coupler	Enables fast and easy connection of air hoses
Pressure Gauge	Monitors air pressure for optimal performance

Installation

Unpack and inspect contents. Place the compressor on a stable surface.

Connect the air hose: Ensure the compressor is off before connecting.
Plug into AC power: Use a grounded outlet to prevent electrical hazards.
Check for leaks: After setup, inspect all connections for air leaks.

WARNING! Ensure the compressor is placed in a well-ventilated area.

First-Time Setup

Power on the compressor and allow it to build pressure.

Set the desired pressure: Use the pressure regulator to adjust.
Connect your tool: Ensure the tool is compatible with the compressor.
Test operation: Run the compressor to ensure proper functionality.

CAUTION! Always wear safety goggles when operating the compressor.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Motor: Low amp for easy start-up.
Weight: Approximately 30 lbs.
Dimensions: 24 x 18 x 18 inches.
Power Source: 120V AC.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel.

Pressure Regulator: Adjusts the output pressure for connected tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Ensure the compressor is off before connecting any devices.

Match the air hose to the quick coupler.
Ensure all connections are secure to prevent leaks.
Power on the compressor and set the desired pressure.

Tip: Always check the compatibility of your tools with the compressor.

Operating the Compressor

Follow these steps to operate the compressor effectively.

Turn on the compressor using the on/off switch.
Allow the compressor to build pressure to the set level.
Connect your pneumatic tool and begin operation.
Monitor the pressure gauge during use.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank regularly to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor.

Keep the compressor away from flammable materials.
Do not operate in wet conditions.
Always wear appropriate personal protective equipment.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor does not start	Power supply issue	Check outlet and power cord.
Low pressure output	Leak in hose or connections	Inspect and tighten connections.
Excessive noise	Loose parts	Tighten all screws and bolts.
Tank does not fill	Faulty pressure switch	Replace pressure switch if necessary.

Service: For further assistance, contact customer support.