Porter Cable N003568 Air Compressor Manual

The Porter Cable N003568 is a compact air compressor designed for a variety of tasks including inflating tires, powering pneumatic tools, and more. It features a 6-gallon tank, a maximum pressure of 150 PSI, and a lightweight design for easy portability. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance and Care 9. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, 150 PSI max pressure, oil-free pump, and easy-to-read pressure gauge.

Feature	Description
6-Gallon Tank	Provides ample air storage for various tasks
150 PSI Maximum Pressure	Delivers high pressure for efficient tool operation
Oil-Free Pump	Requires less maintenance and is cleaner to operate
Easy-to-Read Pressure Gauge	Allows for accurate monitoring of air pressure
Lightweight Design	Easy to transport and maneuver

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure it is securely attached to the compressor outlet.
Plug into a power source: Use a grounded outlet to avoid electrical hazards.
Check for leaks: Turn on the compressor and inspect for any air leaks.

WARNING! Always operate in a well-ventilated area and avoid exposure to moisture.

First-Time Setup

Power on the compressor; follow the setup instructions provided.

Set the desired pressure: Adjust the regulator to the required PSI for your task.
Test the compressor: Run it briefly to ensure proper operation.
Check safety features: Ensure the safety valve is functioning correctly.

CAUTION! Ensure the compressor is on a stable surface during operation.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Power Source: 120V AC.
Weight: Approximately 30 lbs.
Pump Type: Oil-free.
Noise Level: 68 dBA.
Dimensions: 24 x 18 x 18 inches.

Controls and Settings

Access controls via the front panel: Pressure regulator, on/off switch, and pressure gauge.

Regulator: Adjusts output pressure for different tools.

On/Off Switch: Powers the compressor on and off.

Connecting Devices

Connect air tools via the air hose to the compressor outlet.

Ensure the compressor is off before connecting tools.
Match the hose to the tool's air inlet.
Turn on the compressor and adjust pressure as needed.

Tip: Always check for leaks after connecting tools.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor using the on/off switch.
Adjust the pressure regulator to the desired PSI.
Connect your air tool and begin operation.
Monitor the pressure gauge during use.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance and Care

Regular maintenance is essential for optimal performance.

Drain the tank after each use to prevent moisture buildup.
Check and replace air filters as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power source issue	Check power cord and outlet; ensure it's plugged in.
Low pressure	Leak or regulator issue	Inspect for leaks; adjust regulator as needed.
Excessive noise	Worn parts	Check for loose components; replace worn parts.
Tank won't fill	Faulty pump	Contact service for pump inspection.

Service: For support, contact Porter Cable customer service.