Porter Cable Job Boss CFFR350B-CA Air Compressor Manual

The Porter Cable Job Boss CFFR350B-CA is a portable air compressor designed for a variety of tasks, including inflating tires, powering pneumatic tools, and more. It features a 3.5-gallon tank, a maximum pressure of 135 PSI, and a lightweight design for easy transport. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 3.5-gallon tank, 135 PSI maximum pressure, oil-free pump, and lightweight design for portability.

Feature	Description
3.5-gallon tank	Provides sufficient air storage for various tasks
135 PSI maximum pressure	Suitable for powering a wide range of pneumatic tools
Oil-free pump	Requires less maintenance and provides cleaner air
Portable design	Easy to transport and store
Quick recovery time	Reduces downtime between tasks

Installation

Unpack and inspect the compressor. Place it on a stable surface.

Ensure the area is well-ventilated.
Connect the air hose to the compressor outlet.
Plug the compressor into a grounded outlet.
Check for any leaks before operating.

WARNING! Always follow safety precautions when operating the compressor.

First-Time Setup

Power on the compressor and allow it to build pressure.

Set the desired pressure using the regulator.
Connect your pneumatic tool to the air hose.
Test the setup by activating the tool.

CAUTION! Ensure all connections are secure before use.

Specifications

Tank Capacity: 3.5 gallons.
Maximum Pressure: 135 PSI.
Power Source: 120V AC.
Weight: Approximately 40 lbs.
Dimensions: 18 x 18 x 18 inches.
Compressor Type: Oil-free.
Recovery Time: Quick recovery for continuous use.

Controls and Settings

Access controls on the front panel: power switch, pressure gauge, and regulator.

Regulator: Adjusts the output pressure for connected tools.

Pressure Gauge: Displays current tank pressure.

Connecting Devices

Ensure the compressor is off before connecting any devices.

Match the air hose to the compressor outlet.
Connect your pneumatic tool to the other end of the air hose.
Turn on the compressor and set the desired pressure.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

Follow these steps to operate the compressor safely.

Turn on the power switch.
Allow the compressor to build pressure to the set level.
Use the connected tool as needed.
Turn off the compressor when finished.

WARNING! Do not exceed the maximum pressure rating.

Maintenance

Regular maintenance is essential for optimal performance.

Check and clean the air filter regularly.
Drain the tank after each use to prevent rust.
Inspect hoses and connections for wear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Always follow safety guidelines when operating the compressor.

Wear appropriate personal protective equipment.
Keep the compressor in a dry, well-ventilated area.
Do not operate in flammable environments.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power source issue	Check power cord and outlet.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Loose parts	Tighten all screws and bolts.
Tank won't fill	Faulty pressure switch	Replace pressure switch if necessary.

Service: For further assistance, contact customer support.