Porter Cable Job Boss CFFC350B Air Compressor Manual

The Porter Cable Job Boss CFFC350B is a compact and portable air compressor designed for various applications, including inflation, nailing, and stapling. It features a 3.5-gallon tank, a maximum pressure of 135 PSI, and a lightweight design for easy transport. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 3.5-gallon tank, 135 PSI maximum pressure, oil-free pump, and easy-to-read pressure gauge.

Feature	Description
3.5-gallon tank	Provides ample air storage for various tasks
135 PSI maximum pressure	Delivers consistent power for tools
Oil-free pump	Requires less maintenance and provides cleaner air
Lightweight design	Easy to transport and store
Pressure gauge	Allows for easy monitoring of air pressure

Installation

Unpack the compressor and inspect for any damage. Place it on a stable surface away from moisture.

Connect the air hose to the compressor outlet.
Ensure the power switch is in the OFF position before plugging in.
Plug the compressor into a grounded outlet.
Check all connections for leaks before use.

WARNING! Always use the compressor in a well-ventilated area and avoid exposure to moisture.

First-Time Setup

Power on the compressor and allow it to build pressure before using any tools.

Set the desired pressure using the regulator knob.
Check for any air leaks in the hose and connections.
Attach the appropriate tool to the air hose.
Turn on the compressor and monitor the pressure gauge.

CAUTION! Ensure all connections are secure before operating.

Specifications

Tank Capacity: 3.5 gallons.
Maximum Pressure: 135 PSI.
Power Source: 120V AC.
Compressor Type: Oil-free.
Weight: Approximately 30 lbs.
Dimensions: 18 x 18 x 18 inches.
Noise Level: 68 dBA.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. The pressure gauge displays the current tank pressure.

Important: Always adjust the pressure before using any tools.

Connecting Devices

Ensure the compressor is off before connecting any tools.

Attach the air hose to the compressor outlet.
Connect the other end of the hose to the tool.
Turn on the compressor and set the desired pressure.

Tip: Use quick-connect fittings for easy tool changes.

Operating the Compressor

To operate, turn on the compressor and allow it to reach the set pressure before using any tools.

Monitor the pressure gauge during operation.
Turn off the compressor when finished and unplug it.
Release any remaining pressure before storing.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Check and clean the air filter regularly.
Drain the tank after each use to prevent moisture buildup.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Read all safety instructions before operating the compressor. Always wear appropriate personal protective equipment.

WARNING! Do not operate in wet conditions or expose to rain.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check power cord and outlet.
Low pressure	Air leaks	Inspect hoses and connections for leaks.
Excessive noise	Loose parts	Tighten all screws and fittings.
Tank won't fill	Faulty pressure switch	Replace pressure switch if necessary.

Service: For further assistance, contact customer support.