Porter Cable Job Boss Air Compressor 150 PSI Manual

The Porter Cable Job Boss Air Compressor is a versatile and powerful tool designed for various applications, including inflating tires, powering pneumatic tools, and more. With a maximum pressure of 150 PSI, this compressor provides reliable performance and efficiency. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 150 PSI maximum pressure, 6-gallon tank, oil-free pump, easy-to-read pressure gauge, and lightweight design for portability.

Feature	Description
150 PSI Maximum Pressure	Provides sufficient power for various tasks.
6-Gallon Tank	Offers a good balance between size and capacity.
Oil-Free Pump	Requires less maintenance and is easier to use.
Pressure Gauge	Allows for easy monitoring of air pressure.
Portability	Lightweight design with a handle for easy transport.

Installation

Unpack and inspect the compressor. Place it on a stable surface away from moisture.

Connect the air hose: Ensure it is securely attached to the compressor outlet.
Plug into a power source: Use a grounded outlet to prevent electrical hazards.
Check for leaks: Turn on the compressor and inspect for any air leaks.

WARNING! Always ensure the compressor is off and unplugged before making any connections.

First-Time Setup

Power on the compressor; allow it to build pressure before use.

Set the desired pressure: Adjust the regulator to the required PSI for your task.
Test the compressor: Run it briefly to ensure proper operation.

CAUTION! Ensure the area is clear of obstacles before operating the compressor.

Specifications

Max Pressure: 150 PSI.
Tank Size: 6 gallons.
Power Source: 120V AC.
Weight: Approximately 30 lbs.
Pump Type: Oil-free.
Noise Level: 68 dBA.
Dimensions: 24 x 18 x 18 inches.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. The pressure gauge displays the current tank pressure.

Note: Always monitor the pressure gauge during operation to avoid over-pressurization.

Connecting Devices

Ensure the compressor is off before connecting any tools.

Attach the air hose to the tool: Ensure a secure fit to prevent air leaks.
Turn on the compressor: Allow it to reach the desired pressure before using the tool.

Tip: Use quick-connect fittings for easy tool changes.

Operating the Compressor

Follow these steps to operate the compressor safely and effectively.

Turn on the compressor: Flip the switch to the ON position.
Monitor the pressure: Ensure it remains within the recommended range for your tool.
Turn off the compressor: Switch it off when not in use to conserve energy.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank: Release any accumulated moisture after each use.
Check the air filter: Clean or replace as needed to ensure proper airflow.
Inspect hoses and fittings: Look for wear and replace if necessary.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Always follow safety guidelines to prevent accidents.

Do not operate in wet conditions.
Keep the compressor away from flammable materials.
Wear appropriate personal protective equipment (PPE) when using tools.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power source issue	Check power cord and outlet.
Low pressure	Leak in hose	Inspect and replace damaged hoses.
Excessive noise	Loose components	Tighten all screws and fittings.
Compressor cycles frequently	Improper pressure setting	Adjust regulator to the correct PSI.

Service: For assistance, contact Porter Cable customer support.