Porter Cable C2002 Compressor Manual

The Porter Cable C2002 is a 6-gallon pancake air compressor designed for portability and efficiency. It features a powerful 0.8 HP motor that delivers 2.6 SCFM at 90 PSI, allowing for quick recovery time and optimal performance for a variety of tasks. This manual covers key sections including safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating the Compressor 8. Maintenance 9. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, oil-free pump, quick connect coupler, pressure gauge, and a lightweight design for easy transport.

Feature	Description
6-Gallon Tank	Provides ample air supply for various tools
Oil-Free Pump	Requires no maintenance and reduces the risk of oil contamination
Quick Connect Coupler	Allows for easy attachment of air hoses
Pressure Gauge	Monitors tank pressure for optimal performance
Lightweight Design	Easy to carry and transport

Installation

Unpack the compressor and inspect for any damage. Place the compressor on a stable surface away from moisture.

Connect the air hose to the quick connect coupler.
Ensure the drain valve is closed before starting.
Plug the compressor into a grounded outlet.

WARNING! Always ensure the compressor is on a flat surface to avoid tipping.

First-Time Setup

Power on the compressor and allow it to build pressure before using any tools.

Set the desired pressure using the regulator.
Check for any air leaks before operation.
Attach your air tool and ensure it is securely connected.

CAUTION! Do not exceed the maximum pressure rating of your tools.

Specifications

Tank Size: 6 gallons.
Motor: 0.8 HP.
SCFM at 90 PSI: 2.6 SCFM.
Maximum Pressure: 150 PSI.
Weight: Approximately 30 lbs.
Dimensions: 17.5 x 17.5 x 18 inches.

Controls and Settings

The compressor features a pressure regulator, on/off switch, and a pressure gauge for easy monitoring.

Regulator: Adjusts the output pressure to your tools.

On/Off Switch: Located on the front panel for easy access.

Connecting Devices

Ensure the compressor is off before connecting any air tools.

Attach the air hose to the quick connect coupler.
Connect your air tool to the other end of the hose.
Turn on the compressor and adjust the pressure as needed.

Tip: Always check for leaks after connecting devices.

Operating the Compressor

To operate the compressor, turn on the power switch and allow it to build pressure before using any tools.

Monitor the pressure gauge during operation.
Adjust the regulator as needed for your tools.
Turn off the compressor when finished and unplug it.

WARNING! Never operate the compressor in wet conditions.

Maintenance

Regular maintenance is crucial for optimal performance and longevity.

Drain the tank after each use to prevent moisture buildup.
Check and replace the air filter as needed.
Inspect hoses and connections for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor won't start	Power supply issue	Check the outlet and power cord.
No air output	Blocked hose or tool	Inspect and clear any blockages.
Excessive noise	Loose parts	Tighten any loose screws or components.
Pressure drops	Leak in the system	Check for leaks and repair as needed.

Service: For further assistance, contact Porter Cable customer service.