Porter Cable Air Compressor Model C2002 Manual

The Porter Cable C2002 is a 6-gallon oil-free pancake air compressor designed for portability and ease of use. It features a maximum pressure of 150 PSI, providing a quick recovery time and allowing for multiple nailers to be used on a single charge. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Operating Instructions 8. Maintenance 9. Safety Information 10. Troubleshooting

Features at a Glance

Key components: 6-gallon tank, oil-free pump, 150 PSI maximum pressure, quick recovery time, and lightweight design for portability.

Feature	Description
Oil-free pump	Requires no maintenance and reduces the risk of oil contamination.
150 PSI maximum pressure	Provides a quick recovery time for continuous use.
6-gallon tank	Offers a good balance between portability and air supply.
Low noise level	Operates quietly, making it suitable for indoor use.
Lightweight design	Easy to transport and store.

Installation

Unpack the compressor and inspect for any damage. Place it on a stable surface away from moisture.

Connect the air hose to the compressor outlet.
Ensure the pressure regulator is set to the desired level.
Plug the compressor into a grounded outlet.
Turn on the compressor and allow it to build pressure.

WARNING! Ensure the compressor is on a flat surface to avoid tipping.

First-Time Setup

Power on the compressor and allow it to reach the maximum pressure before use.

Check all connections for leaks.
Set the pressure regulator to the desired PSI for your tools.
Test the compressor with a small air tool to ensure proper operation.

CAUTION! Always wear safety goggles when operating air tools.

Specifications

Tank Size: 6 gallons.
Maximum Pressure: 150 PSI.
Power Source: 120V AC.
Weight: Approximately 30 lbs.
Noise Level: 68 dBA.
Pump Type: Oil-free.
Recovery Time: Quick recovery for continuous use.

Controls and Settings

Access the pressure regulator and on/off switch located on the front panel. Ensure the pressure gauge is visible for monitoring pressure levels.

Safety Features: Automatic shut-off when maximum pressure is reached, thermal overload protection.

Connecting Devices

Connect air tools using the appropriate fittings for your air hose.

Ensure the compressor is off before connecting tools.
Match the tool's fitting to the air hose connector.
Turn on the compressor to begin using the tool.

Tip: Always check for leaks after connecting tools.

Operating Instructions

To operate the compressor, turn on the power switch and allow it to build pressure. Use the pressure regulator to adjust the output pressure as needed for your tools.

Monitor the pressure gauge during operation.
Turn off the compressor when not in use.
Drain the tank regularly to prevent moisture buildup.

WARNING! Do not exceed the maximum pressure rating of your tools.

Maintenance

Regular maintenance is essential for optimal performance.

Drain the tank after each use.
Check and clean the air filter regularly.
Inspect hoses and fittings for wear and tear.

CAUTION! Always unplug the compressor before performing maintenance.

Safety Information

Always follow safety guidelines when operating the compressor. Wear appropriate personal protective equipment and ensure the work area is well-ventilated.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Compressor does not start	Power supply issue	Check the power cord and outlet.
Low pressure	Leak in hose or fittings	Inspect and replace damaged parts.
Excessive noise	Worn components	Check for loose parts and tighten as necessary.
Tank does not fill	Faulty pressure switch	Replace the pressure switch if necessary.

Service: For assistance, contact Porter Cable customer service.